Want to get started

Social Media

TOPIC: Want to get started

Re: Want to get started 10 years, 4 months ago #19403

Brian Evans OFFLINE Seasoned Racer Posts: 285	AEvans wrote: That picture looks pre-clear coat. Where are the good pictures?! You know, I don't think I took any after the clear coat. Will be sure to get some posted ASAP, lest anyone question your painting skills!
	#08 NASA Southeast 944-Spec Reply Quote

Re: Want to get started 10 years, 4 months ago #19404

early70scamaros OFFLINE Moderator Posts: 64	Might need to "borrow" that paint booth some day...
	Shawn Taylor Regional Director NASA Mid South Reply Quote

Re: Want to get started 10 years, 4 months ago #19405

Brian Evans OFFLINE Seasoned Racer Posts: 285	early70scamaros wrote: Might need to "borrow" that paint booth some day... Says the guy running his AI car the weekend of the Small Bore Shoot Out I just hope you paint better than you shift, Shawn, or we are in for quite a mess...
	#08 NASA Southeast 944-Spec Reply Quote

Re: Want to get started 10 years, 4 months ago #19407

AgRacer OFFLINE Administrator Posts: 712	Brian Evans wrote: early70scamaros wrote: Might need to "borrow" that paint booth some day... Says the guy running his AI car the weekend of the Small Bore Shoot Out I just hope you paint better than you shift, Shawn, or we are in for quite a mess... And boom goes the dynamite...
	J. Stanley NASA-SE Region 944 Spec Series Director Yellow #60 Reply Quote

Re: Want to get started 10 years, 4 months ago #19410

early70scamaros OFFLINE Moderator Posts: 64	AgRacer wrote: Brian Evans wrote: early70scamaros wrote: Might need to "borrow" that paint booth some day... Says the guy running his AI car the weekend of the Small Bore Shoot Out I just hope you paint better than you shift, Shawn, or we are in for quite a mess... And boom goes the dynamite... Sadly, it is all deserved. I still have two project 944s I may get to one day...
	Shawn Taylor Regional Director NASA Mid South Last Edit: 10 years, 4 months ago by early70scamaros. Reply Quote

Re: Want to get started 8 years, 2 months ago #21797

brad.t
OFFLINE
Drivers Ed
Posts: 19

Well 2 years later I am ready to do this.

I have a 924S that was built for fun so it needs some work to move towards SP1.
Motor is a stock 87 N/A so low compression pistons (dang).
LSD trans, 968 M030 bars, 30mm torsion bars, 350lb springs over Konis, manual steering, manual windows, manual mirrors.
However it also has Stahl headers, Wilwood brakes, some bushings replaced with spherical bearings, aftermarket splitter, etc. So I have some un-modding to do.

It also needs a cage as it has a simple roll bar.

Forward half of the interior is still intact so there's some work to do there as well, thankfully most of the interior is gone already.

So be on the lookout for some WTB and some progress posts...